16
STAT
Ch
Fn
α
T2000II
6. After the call is sent, you may hear an acknowledging tone,
beep
, or series of tones from the other
user’s radio, indicating that your call has been received. If you do not hear a tone, either the other
user's radio is incapable of generating the acknowledging tone, or it is off, or they are out of range
of your call.
Your T2020
II
may be programmed to display the status of the called unit, as follows:
Status displayed Explanation
‘-NO ACK-’ No acknowledge sequence was detected.
‘NO STAT’ An acknowledge sequence was detected but no status information was de-
coded.
Status message An acknowledge sequence was detected and the decoded status number
can be identified.
Status number An acknowledge sequence was detected and the decoded status number
cannot be identified.
If any control head activity is detected before any of the above messages are displayed, the acknowl-
edge sequence is no longer expected, and messages will therefore no longer be displayed.
Group Calls
If you wish to call a group of other users, you may do so by dialling the digits common to all members of
the group and then using the # character as a substitute for all the remaining digits. If you are not sure
whether this facility has been programmed into your radio, consult your Tait dealer.
To Next Page
Loading...
Need help?
General
