Tait TB9100 Service Manual

TB9100 Reciter Service Manual RF Circuitry 99
© Tait Electronics Limited January 2006
Modulation Based
on Varicap Diodes
Modulation on the VCO is provided by an auxiliary varicap-based control
circuit which provides a modulation gain of 5kHz/V
p
.
Low Noise Amplifier A BJT cascode amplifier is used as a broad band isolator and low noise
amplifier. This has internal self-bias circuitry, and the output provides
enough RF power to drive the following stages.
Harmonic Filter The VCO has a relatively high harmonic content. A third order low pass
elliptic filter is used to attenuate this content.
Fixed Slope
Attenuator, Final
Driver and Fixed
Attenuator
A silicon BJT is used as a broad band matched Class A final driver to drive
the +20dBm local oscillator port of the mixer. To maintain a fixed output
level, a fixed slope attenuator is introduced at the input to the final driver so
that the attenuation rate (slope) increases with an increase in frequency.
A fixed attenuator provides a signal level of +11dBm ± 2dB to the input
port of the PA, providing better reverse isolation.
The B band VCO frequency spans from either 136MHz to 156MHz, or
148MHz to 174MHz, according to the product type.
6.3.4 VCO - UHF Reciter
The exciter VCO consists of a high Q VCO, modulation based on varicap
diodes, low noise amplifier, harmonic filter, fixed slope attenuator, final
driver and a fixed attenuator.
High Q VCO The VCO BJT transistor operates in a common collector, Colpitts oscillator
configuration, and uses a shorted quarter-wave ceramic coaxial resonator.
The open end of the resonator is terminated by a combination of a high Q
trimmer and varactor diodes. This forms a high Q resonator which is both
mechanically and electronically tunable. Mechanical tuning is possible by
adjusting the trimmer. Changes in the control voltage from the loop filter
are applied to the varactors to facilitate electronic tuning.
Modulation Based
on Varicap Diodes
Modulation on the VCO is provided by an auxiliary varicap-based control
circuit which provides a modulation gain of 5kHz/V
p
.
Low Noise Amplifier An N-channel dual gate MOSFET is used as a broad band matched Class A
low noise amplifier. It has internal self-bias circuitry, and the output provides
enough RF power to drive the following stages.
Harmonic Filter The VCO has a high second harmonic content. A third order low pass
elliptic filter is used to attenuate this content.

Tait TB9100 Specifications

General

Brand	Tait
Model	TB9100
Category	Accessories
Language	English