Tait TB9100 User Manual

TB9100/P25 CG/P25 TAG Installation and Operation Manual Replacing Modules 97
© Tait Limited March 2014
3. If the base station is using a 12V PA, disconnect the battery supply
lead g.
Remove the Front
Panel
1. Undo the fastener at each end of the front panel b with a quarter
turn anti-clockwise.
2. While supporting the left end of the front panel, place your fingers in
the recess provided on the left side of the control panel opening
c
and pull the right end of the front panel away from the subrack. You
will need to overcome the resistance of the spring clip securing the
front panel to the control panel.
bcdef
PMU
12V PA
g
b
lockedunlocked
c

Tait TB9100 Specifications

General

Brand	Tait
Model	TB9100
Category	Accessories
Language	English