TN-2776h-AN www.taitradio.com Page 11 of 16
The equipment required to validate the environment water sealing on a TP3000 radio is the
Pressure Tester shown below.
Operation
1. Select the 6 mm test nozzle.
2. Connect the test nozzle to the end of the pressure tester.
3. Validate the pressure tester against a flat surface:
a. Pump in some air.
b. The pressure should hold and not gradually decrease.
c. Check the release valve above the pump bulb, it should be closed.
To Next Page
Loading...
Need help?
General
