13
ELECTRICAL CONNECTION
1. The water heater must be electrically grounded. Do not aach the
ground wire to either the gas or water piping.
2. The water heater requires an AC 240V 50Hz electrical power supply and
draws a current of 0.8A.
3. The weather-proof power point should be no more than 1 metre from
the base of the water heater for easy access.
4. Install so that the electrical power can be switched o if necessary.
5. If the cord supplied with this appliance must be replaced, it must be
replaced with appliance wiring material supplied by the Manufacturer.
Weather-proof
Power Point
WARNING
When servicing or replacing parts within the water heater, label all wires prior to disconnecon
to facilitate an easy and error free reconnection. Wiring errors can cause improper and
dangerous operaon. Verify proper operaon aer servicing.
To Next Page
Loading...
