Takagi GS-2600W-AU User Manual

14
REMOTE CONTROLLER (OPTIONAL)
The water heater can be installed with up to three remote controllers. Each remote controller has two
funcons which can adjust the set temperature and indicate the error code on the remote controller.
• The set temperature can be adjusted only by a remote controller which has the priority seng (when a
remote controller has the priority seng, PRIORITY lamp on the remote controller is lit), and the other
remote controller(s) display the set temperature. If you desire to transfer the priority seng, you can
transfer it by pressing the PRIORITY buon only when there is no water ow through the water heater.
(Default set temperature is 40 °C.)
• All water heater models have a self diagnosc funcon for safety and convenience when troubleshoong.
If there is a problem with the installaon or the unit, it will display a numerical error code on the
remote controller (or the LED of the computer board will blink.)
MAIN REMOTE CONTROLLER (MODEL: MC100-AU3-TP)
• Location-MC100-AU3-TP must be installed in dry, shaded and
clean locations (such as kitchen) due to NO water resistant. Be
careful of installation location.
• The controller can adjust the output water temperature within the
range of 37 °C to 55 °C.
• The temperature opons are:
37 °C, 38 °C, 39 °C, 40 °C, 41 °C, 42 °C, 43 °C, 44 °C, 45 °C, 46 °C, 47
°C, 50 °C, 55 °C.
• When “BURNER ON” lamp is lit, the set temperature can not be
adjusted to 55 °C. If you desire to set it to 55 °C, you should close
the hot water tap.
SHOWER CONTROLLER (MODEL: FC100-AU3-TP)
AND ENSUITE CONTROLLER (MODEL: SC100-AU3-TP)
• FC100-AU3-TP and SC100-AU3-TP controllers are water resist-
ant, however should not be posioned where they can be splashed
directly and there should be caulking between the surface of the
wall and the controller.
• FC100-AU3-TP is installed such as the main bathroom, and
SC100-AU3-TP is installed such as the ensuite bath room.
• These remote controllers allow the output temperature from the
water heater to be adjusted within the range of 37 °C to 50 °C.
• The temperature opons are:
37 °C, 38 °C, 39 °C, 40 °C, 41 °C, 42 °C, 43 °C, 44 °C, 45 °C, 46 °C,
47 °C, 50 °C.
• When BURNER ON lamp is lit, the set temperature can not be ad-
justed to 42 °C or over. If you desire those temperatures, you should
close the hot water tap.
Main
Shower
Ensuite
MC100-AU3-TP
FC100-AU3-TP
SC100-AU3-TP

Takagi GS-2600W-AU Specifications

General

Brand	Takagi
Model	GS-2600W-AU
Category	Water Heater
Language	English