16
CONNECTION OF REMOTE CONTROLLER WIRING
TO THE WATER HEATER
1. Turn o the power supply to the water heater.
2. Remove the front cover from the water heater. There are 3 screws on the front cover.
3. Put the remote wires through the hole on the boom of the unit’s casing.
4. Remove the plasc cover and connect the remote control wires to the remote terminals directly.
(There is no polarity in the terminaons.)
*DO NOT jump or short-circuit wires as it will damage the computer.
5. Replace the plasc cover and the front cover. Then connect the power plug.
1 2 3 4 5 6 7 8
PL A S T IC
CO V E R
RE MO T E CO N TR OL
CA BL E
RE M O T E C O N TR O L
TE R M I NA L
RE M O V E T H E P L A S TI C C OV E R
AN D C ON N E C T T O TE R M I NA L S
DI R E C TL Y B EH I N D T H E CO V E R
REMOTE CONTROLLER – CABLE CONNECTIONS
Put the remote wires through the
hole on the boom of the unit’s
casing.
1 2 3 4 5 6 7 8
TYPICAL CABLE LAYOUT
FC100-AU3-TP SC100-AU3-TP
MC100-AU3-TP
To Next Page
Loading...
Need help?
General
