Takagi T-KJr2-IN User Manual

Installation
26│Page
 A remote controller is not required for the Easy-Link system.
 If running the Easy-Link system without a remote controller, please make sure the
temperature settings on ALL the units are set to the same settings. Otherwise, the
units will not operate properly.
 If a remote controller is used, the temperature on all the units in the system will
automatically be set to the same temperature that is set on the remo
te.
CASE 1:
 Unless you change dipswitch No.1 of the “PARENT” unit to the “ON” position, the
system will not work as an Easy-Link system. The units will operate as individual units.
CASE 2:
 If you connect the “[1] (or [2])” connector of the “PARENT” unit to the “PARENT (or [1])”
connector of the “CHILD-1” unit, the system will not work as an Easy-link system. The units will
operate as individual units.
Wrong dipswitch
setting on the
“PARENT” unit
Wrong connections between the “PARENT” unit and the “CHILD-1” unit
(C) Example
s
of incorrect settings and/or connections
Prohibited
Prohibited
NOTICE
OR
W
rong S
etting
PARENT
unit
CHILD
-
1 unit
Communication cable
OFF
ON
OFF
ON
2
1
2
1
2
1
2
1
P A R E N T P A R E N T
Con ne ct ors C onne ct or s
1 2 3 4 5 6 1 2 3 4 5 6
Right bank of DipswitchesRight bank of Dipswitches
Communication cable
OFF
ON
OFF
ON
2
1
2
1
2
1
2
1
P A R E N T P A R E N T
Co n n ec t or s Co n n ec t or s
1 2 3 4 5 6
Right bank of Dipswitches
1 2 3 4 5 6
Right bank of Dipswitches
Wrong
Connections
PARENT
unit
CHILD
-
1 unit
Communication cable
OFF
ON
OFF
ON
2
1
2
1
2
1
2
1
P A R E N T P A R E N T
1
2 3 4 5 6
Right bank of Dipswitches
1
2 3 4 5 6
Right bank of Dipswitches
Co nne c t o rsCon ne c t or s
Wrong
Connections
PARENT
unit
CHILD
-
1 unit

Takagi T-KJr2-IN Specifications

General

Brand	Takagi
Model	T-KJr2-IN
Category	Water Heater
Language	English