119
MAINTENANCE
K3G003
1
Replacing the Hydraulic Oil
Return Filter
Refer to page 108 “Replacing the Hydraulic
Oil Return Filter”.
Replacing the Fuel Filter
WARNING
¡¡
¡¡
¡Do not smoke or permit open flames
while handling fuel or working on the
fuel system.
¡¡
¡¡
¡Stop the engine in a well-ventilated
place and allow it to cool down before
performing maintenance.
¡¡
¡¡
¡Clean up spilled fuel immediately.
1. Open the engine hood.
2. Using a filter wrench, turn the filter (1)
counterclockwise and remove it.
3. Clean the filter installation surface on the
filter stand.
4. Apply a thin layer of oil to the packing of
the new filter.
5. Install the new filter by hand.
6. Tighten 2/3 more turn with the filter wrench
after the filter packing comes in contact
with the surface of installation.
7. Bleed the air.
Refer to page 139 “Bleeding the air from
the fuel system”.
Every 500 Hours
To Next Page
Loading...
Need help?
General
