89
OPERATION
Operating Procedures
Getting Out of Mud
If the machine gets stuck in mud, use the
procedure below to get it out.
If tires on one side are stuck
1. Slew the bucket to the side which is
stuck.
2. Set the arm and boom to an angle of 90 to
110°.
3. Press the bottom of the bucket (not the
teeth) against the ground.
4. Place a plank, etc., under the lifted tires.
5. Raise the bucket and slowly move out of
the mud.
If all tires are stuck
1. Perform steps 1 to 4 above for both tires.
2. Dig the bucket into the ground in front of
the machine.
3. Pull with the arm and travel forward
simultaneously to slowly move out of the
mud.
To Next Page
Loading...
