Takeuchi TB225 User Manual

2-55
CONTROLS
ACCESSORIES
(1) POWER button
Use this button to turn on or off the
radio.
(2) LCD
<Home screen>
(1) Operation mode
USB: USB audio mode
BT: Bluetooth mode
AUX: Auxiliary in mode
(2) Volume level
(3) Audio control (For USB audio or
Bluetooth mode only)
<Radio mode screen>
(1) Radio band display
FM1, FM2 FM3: FM band (Six stations
can be preset to each band.)
MW: AM band
(2) Stereo display
Turns on when receiving stereo.
(3) Preset station
(4) Display of frequency/clock
Displays the time/the receiving frequency
and the operation mode.
(3) Clock button (CLOCK)
Pressing this button changes the display
to the clock. Pressing the button again
displays the frequency. If the button is
not pressed for three seconds, the
display returns to the frequency.
Pressing and holding the button enters
the clock setting mode.
(4) Auto store/Auto seek station (SCAN)
Press this button to automatically assign
receivable radio stations to preset
buttons (1 to 6).
(5) Tuning button (TUNE
)
Press and hold this button (TUNE
or
TUNE
) for two seconds or more to
start seeking the receivable stations. The
seeking stops when a station is found.
To cancel tuning halfway, press the
button again.
Pressing the TUNE
button starts
seeking stations with higher frequency.
Pressing the TUNE
button starts
seeking stations with lower frequency.
(6) Preset buttons (1 to 6)
(PRESET STATION)
Each button can store three FM stations
(FM1, FM2, FM3) and one MW (AM)
station.
(7) Band button (BAND)
Pressing this button changes the band
from FM1 to FM2, FM3 and MW (AM), in
this order.

Takeuchi TB225 Specifications

General

Engine Make	Yanmar
Max Dig Depth	2, 580 mm
Bucket Capacity	0.03 - 0.11 m3
Max Reach	7, 010 mm
Max Digging Depth	3, 870 mm