Takeuchi TB225 User Manual

2-57
CONTROLS
ACCESSORIES
Playing the radio
1. Select the band, FM or MW (AM) by
pressing the BAND button.
2. Select the station with the preset button or
the tuning button.
3. Adjust the volume with the VOL (
or )
button.
Seeking stations (auto)
Press and hold the TUNE
button for two
seconds or one to start seeking stations in
the higher frequencies direction. Press and
hold the TUNE
button for two seconds or
more to start seeking stations in the lower
frequencies direction. The radio will stop
seeking when it finds a receivable station and
start playing.
Manual tuning
Press the TUNE
button to increase the
frequency by one step. Press the TUNE
button to decrease the frequency by one
step.
Presetting stations
1. Press the BAND button to select a band
(MW (AM) or FM), and then select the
desired station.
2. To assign the selected station to a preset
button, press and hold the button to be
assigned for three seconds or more. The
number of the preset button appears on
the LCD to indicate that it is stored in the
preset memory.
3. For more stations to preset, repeat the
steps 1 and 2 above.
• Each preset button (1 to 6) can store
three FM stations (FM1, FM2, FM3) and
one MW (AM) station.
Auto storing stations (SCAN)
Press the SCAN button while playing the
radio. The radio automatically starts seeking
the receivable stations in the band currently
selected and assign each preset button (1 to
6) a station.
Note: The previous stations stored will be
cleared (cancelled) by the auto storing. If the
station stored in the preset button is not
desirable, try to preset the station manually.

Takeuchi TB225 Specifications

General

Engine Make	Yanmar
Max Dig Depth	2, 580 mm
Bucket Capacity	0.03 - 0.11 m3
Max Reach	7, 010 mm
Max Digging Depth	3, 870 mm