Takeuchi TB225 User Manual

2-28
CONTROLS
INSTRUMENT CLUSTER
SIDE MENU SCREEN
To display the side menu, turn the starter
switch from the OFF to the ON position while
pressing the (C) key.
Press the (A) key to proceed to the screen
selected by the bar.
Press the (B) key to move the selection bar.
• SETTING
The flow rate ratio of the auxiliary circuits
(Auxiliary 1st, Auxiliary 2nd and Auxiliary
4th) can be set.
• MAINTENANCE
Diagnosis and failure record can be
checked.
• Contrast setting (CONTRAST)
Adjust the LCD contrast.
a. When the selection bar is at CONTRAST,
press the (A) key to proceed to the
contrast setting screen (CONTRAST).
b. To increase contrast, press the (B) key.
The bar advances to the right.
Press and hold the (B) key to rapidly
advance the bar.
Once the bar reaches the right end
(highest contrast), it returns to the left
end (lowest contrast).
c. Press and hold the (A) key for at least
three seconds to complete the setting
and to return to the Setting Selection
screen.
d. Press the (C) key to cancel editing and
to return to the Setting Selection screen.
The changes made to the setting are
reflected, but they will be removed when
the starter switch is turned off.

Takeuchi TB225 Specifications

General

Engine Make	Yanmar
Max Dig Depth	2, 580 mm
Bucket Capacity	0.03 - 0.11 m3
Max Reach	7, 010 mm
Max Digging Depth	3, 870 mm