136
MAINTENANCE
When Required
6. Check that the rubber crawler is securely
engaged on the sprocket and idler.
7. Tighten the rubber crawler to the standard
tension.
Refer to page 113 “Inspecting and
Adjusting the Crawler Tension”.
8. Install the other rubber crawler using the
same procedure.
Cleaning the Water Separator
WARNING
¡¡
¡¡
¡Do not smoke or permit open flames
while handling fuel or working on the
fuel system.
¡¡
¡¡
¡Stop the engine in a well-ventilated
place and allow it to cool down before
performing maintenance.
¡¡
¡¡
¡Clean up spilled fuel immediately.
S : Closed
1. Open the engine hood.
2. Close the cock (2).
3. Loosen the ring (3), then remove the case
(4), element (5) and indicator ring (6) and
clean them.
4. Inspect the O-ring, and if there are any
scratches or other irregularities, replace it.
5. Assemble the indicator ring (6), case (4)
and element (5) and tighten the ring (3).
6. Open the cock (2) and bleed the air.
Bleeding the air from the fuel system
Refer to page 143 “Bleeding the Air from the
Fuel System”.
J1G0021
ON
OFF
6
3
S
5
4
2
1
7
8
To Next Page
Loading...
