33
SAFETY
Safety Signs (Decals)
1. No.03593-06500
2. No.03593-07400
3. No.03793-37300
4. No.03593-13700
6. No.05693-21980
5. No.03993-51406
DO NOT
enter into
swinging area
WARNING
WARNING
03793-37300
If the platform is raised or lowered while the
engine is running, the machine may start
moving.Be sure to stop the engine first.
If you need to run the engine while the
platform is raised, follow the instructions
below.
(Refer to the Instruction Manual.)
1. Place the machine on a stable, level
surface, and stop the engine.
2. Lock the operating lever.
3. Tilt-up the platform.
4. Insert the stopper to prevent platform from
dropping.
5. Make sure that all levers and pedals are in
neutral positions.
6. Push the throttle lever fully forward.
(Low idling)
7. Start the engine.
8. After inspection and maintenance is
compiete, stop the engine,
WARNING
This machine,if improperly operated or
maintained can cause bodily harm,or even
DEATH.
Read and understand the owners manual
supplied with this machine before operating.
Keep all safety devices in place and
functional.
Do not operate the machine unless the seat
belt is properly fastened around you.
Follow the instructions in the Operator’s
Manual when hoisting the machine or
fastening it to the transport vehicle.
03593-13700
1 -
2 -
3 -
4 -
5 -
CAUTION
03593-07400
STOP ENGINE
BEFORE OPENING
WARNING
Handling the interference prevention system
To ensure operator safety, this excavator is equipped
with a system which autmatically stops boom or bucket
when it approaches the cab to prevent it from hitting the cab
CAUTIONS ON USE
*Do not disassemble or damage the sensors installed
on the boom and main body.
In addition, do not install attachments other than
those designated by Takeuchi. The interference
prevention system may not function properly if other
attachments are installed.
Operation when the boom has stopped automatically
If the boom has stopped:
Operate the boom downward.
If the offset pedal is loched and
offsetting is not possible:
1.Operate the boom downward to mov
e
it outside the automatic stop range.
2. Offset to the left.
*Offsetting to the right is possibl
e
regardiess of the boom's postuer.
Preliminary Inspection
Perform the inspection poeration operations described below and check
that the bucket, arm and boom do not touch the cab when the boo
or bucket is moved near the cab and stops automatically.
Upper part of cab
Offset the boom to the fornt of the poerator's seat
and move the boom near the cab.
Offset the boom to the right and move the bucket near the cab.
Offset
Offset the boom fully to the right and check thant it
can be set to the maximum rear inclination.
Offset to the left in the posture in above.
03993-51406
エ
2
3
1
2
2
1
3
1
2
1
2
To Next Page
Loading...
Need help?
General
