34
SAFETY
Safety Signs (Decals)
8. No.03593-47010
WARNING
03593-47010
THIS EXCAVATOR
MUST NOT BE USED
AS A CRANE
9. No.03393-75040
CAUTION
03393-75040
DO NOT USE ETHER
USAGE OF ETHER FOR STARTING
PURPOSES MAY CAUSE INTERNAL
ENGINE DAMAGE.
10. No.03393-75050
CAUTION
03393-75050
HYDRAULIC TANK MUST REMAIN
PRESSURIZED TO AVOID DAMAGE
TO PUMPS.
11. No.03393-68100
WARNING
03393-68100
WHEN BUCKETS WIDER THAN STANDARD
ARE FITTED TO THIS MACHINE,
CAB(CANOPY)DAMAGE MAY OCCUR WHEN
FULL RIGHT HAND BOOM OFFSET IS USED.
05693-53810
Setting this switch to the “OFF”
position will shut down all of
the electrical circuits and the
memory of the radio preset
tuning buttons will be deleted.
CAUTION
15. No.05693-53810
Diesel Fuel Only
03593-06600
D
16. No.03593-06600
Diesel Fuel
17. No.03593-06700
Hydraulic oil
18. No.03993-54628
Noise Outside the Cab
This value indicates the noise level
outside the machine and refers to the
noise perceived by the persons who
are in the vicinity of the work area.
for USA
14. No.03993-52309
The Attachment Interference Switch (AIS)
is automatically set to the M mode by the
Interference Prevention System (IPS) when
the engine is started.
To use the minimal front radius feature,
reset the AIS to the M position then select
the appropriate attachment width(S.L or M)
03993-52309
for USA
12. No.03993-52302
WARNING
03993-52302
DO NOT ENTER
INTO PINCH AREA.
13. No.03993-52303
WARNING
03993-52303
Failure to properly set the Attachment
Interference Switch can result in
equipment damage, bodily harm, or death.
for USA
To Next Page
Loading...
Need help?
General
