MAINTENANCE
Every
50
Hours
Inspecting the Bucket Stoppers
(bolts
I nuts)
AwARNING
Before performing maintenance or
repairs under the machine, set
all
working
equipment against the ground or
in
the
lowermost position.
~Parallel
T8G006E
1. Park the machine on firm, level ground
and remove the bucket.
2.
Retract the bucket cylinders and lift arm
cylinders to the minimum length.
3. Inspect the adjusting bolts
(1)
and lock
nuts
(2)
for bending, denting, deformation
and looseness.
4.
If there are any irregularities with the
adjusting bolts
(1)
and lock nuts
(2).
Refer to page 142 "Adjusting or Replacing
the Bucket Stoppers (bolts/nuts)".
135
To Next Page
Loading...
