OPERATION
Starting and Stopping
the
Engine
Before Starting the Engine
1. Adjustthe seat for a comfortable operating
position.
2.
Fasten the seat belt.
T7B015
3.
Check that the safety bar
is
in
the locked
position.
4.
Check that the control levers and pedal
are
in
the neutral position.
o~
PREHEAT ON
' I
~,,,
START
J2D002E
5.
Insert the key into the ignition switch, turn
it
to the
ON
position, then perform the
following inspection:
75
IJ
§J0~@1!1ill00
1 1 1
lP
~
~
r
III
T7D0033
•
All
the warning lamps flash and
an
alarm
is
sounded for 2 seconds. The
instruments also start functioning. After
2 seconds, only the battery charge
warning lamp
(3)
and engine
oil
pressure
warning lamp
(1)
flash, and the other
lamps turn off.
•
Turn
the light switch to check that the
front lights, tail lights and instruments
lights turn on.
• Check the fuel level.
If a lamp does not light or the alarm
is
not
sounded, the bulb may be burned out or a
wire may be damaged. Contact a Takeuchi
dealer for repairs.
To Next Page
Loading...
Need help?
General
