MACHINE DESCRIPTION
• Front, rear, left and right
This manual refers the front,
rear,
left and
right
of
the machine as seen when sitting
in
the operator's seat with the bucket visible
to
the front.
• Designated operations
Use this machine primarily for the following
operations:
• Carrying
• Leveling
• Loading
•Features
• Hydrostatic drive system
FRONT
LEFT
REAR
• Roll Over I Falling Object Protective Structure (ROPS/FOPS), tilt-up Canopy
• Low engine noise and exhaust emissions
• Two-way auxiliary hydraulics
• Pilot-operated joystick controls
• Break-in period
RIGHT
T7A004E
When the machine
is
new, follow the instructions below when operating the machine for the
first 100 hours
(as
indicated on the hourmeter).
Using a new machine roughly without breaking it
in
will lead
to
quicker deterioration
of
machine
performance and may shorten the machine's service life.
• Warm
up
the engine and hydraulic oil sufficiently.
• Avoid heavy loads and rapid operations. Operate with a load
of
about
80%
of
the maximum
load.
• Do not start up, accelerate, change directions,
or
stop abruptly unless necessary.
3
To Next Page
Loading...
Need help?
General
