Tally Dascom 1145 - Page 42

Tally Dascom 1145/1125+
27
Paper Setup
Valid Settings
Function
APW (Auto
Paper Width
detection)
No, Yes
Yes: Measures the width of the paper automatically
after loading the paper.
No: Disables page width measurement.
NOTE:
The printer is equipped with a page width sensor
called “APW”.
When the sensor is defective, the “APW” setting will
not appears in the menu; The【Power】LED blinks,
【Front 1】and【Front 1】have no change,
【Online】LED is off.
APS
(Auto Page
Skew
detection)
Invalid, Normal,
Precise
Invalid: The printer will not detect paper skew.
Normal: The printer ejects any paper with serious
skew.
Precise: The printer ejects any paper with slight
skew.
NOTE:
This paper skew sensor called “APS” is an option.
The APS setting will not appear in the menu if it is
not installed or defective.
BlackMark
No, Yes
No: Disables black mark sensor.
Yes: Enables black mark sensor.
When “Yes” and online, pressing the Load/Eject key
advances the paper to the tear-off position.
BlackMark commands: (also see section 5.7)
 1D 0C:
Feeds paper to the print position designated by
the black mark. Advance the paper to the tear-off
position after printing.
 1C 28 4C 03 00 42 m:
m = 0: feeds paper to the print position designated
by the black mark.
m = 1: feeds paper to the black mark tear-off
position.
Width
8.0inch,
PaperWidth
8.0inch: The maximum print width is 80 columns of
10cpi PICA characters.
Paper Width: Sets the detected page width as print
width. Enabling APW is required.