What to do if my Tally Dascom DT-210 has a paper jam?
If your Tally Dascom Printer is experiencing a paper jam, here's what you should do: * Open the printer cover. * Check the paper path. * Remove any jammed paper.
Why is my Tally Dascom Printer printing blurred or spotty?
Blurred or spot printing on your Tally Dascom Printer can occur due to several reasons: * The paper roll might be installed incorrectly; ensure it is installed correctly. * The paper quality might be poor; use recommended thermal roll paper. * The thermal head or print roller could be dirty; clean them. * The print density might be set too low; increase the print density level.
What to do if Error LED blinks and beeper alarms on Tally Dascom Printer?
If the Error LED blinks and the beeper alarms on your Tally Dascom Printer, it could be due to: * The thermal print head is overheated: Turn the printer off and wait some minutes before you resume. * Overvoltage or Low-voltage: Print with specified voltage, use original power adapter.
What to do if Power, Paper and Error LEDs always on and beeper alarms on Tally Dascom DT-210?
If the Power, Paper, and Error LEDs are always on and the beeper alarms are sounding on your Tally Dascom Printer, it indicates that the paper has run out. To resolve this, reload the roll paper.
How to fix vertical dot line missing on Tally Dascom Printer?
If you're experiencing a missing vertical dot line on your Tally Dascom Printer, the thermal head or print roller may be dirty. Clean the thermal head or print roller to resolve this issue.
What to do if Paper LED always on Tally Dascom DT-210 Printer?
If the Paper LED is always on in your Tally Dascom Printer, it means the roll paper is near the end. The printer can still work normally, but you should procure a new roll.
Why my Tally Dascom DT-210 has no LEDs on?
If there are no LEDs lit on your Tally Dascom Printer, it could be due to incorrect power supply cable connections and power outlet. Check the power supply cable connections and the power outlet and correct them. If the problem persists, the PCB may be damaged, and you should contact your dealer for assistance.
What to do if Error LED always on and beeper alarms on Tally Dascom DT-210 Printer?
If the Error LED is always on and the beeper is alarming on your Tally Dascom Printer, ensure that the printer cover is securely closed. This should resolve the issue.
What causes insufficient cutting on Tally Dascom DT-210?
Insufficient cutting on your Tally Dascom Printer can be caused by cutter edge abrasion or using paper that is too thick. The suggested solution is to replace the cutter.
What causes a colored stripe in the paper from Tally Dascom Printer?
A colored stripe in the paper from your Tally Dascom Printer can be caused by cutter abrasion or insufficient cutting. Replace the cutter to resolve this issue.
General| Brand | Tally Dascom |
|---|---|
| Model | DT-210 |
| Category | Printer |
| Language | English |
To Next Page
