Talsa H26 - Cleaning Recommendations; General Recommendations for Manual Cleaning

H PISTON FILLERS/STUFFERS
MANUAL
EN-28
Warning!
 ALWAYS use caution when removing the piston for maintenance or cleaning operations since it is heavy
and there’s a risk of injury should the piston fall during dismantling
 Never fill the barrel with water since the water could seep down into the machine’s base and damage
electrical and mechanical components. Avoid getting water into the air vent holes at the bottom of the barrel.
 Make sure that the bottom of the cylinder is completely DRY before reassembling the piston since residual
moisture could eventually lead to the formation of rust on the upper part of the base.
 To avoid damaging the gaskets, never use sharp or pointed tools (knives, screwdrivers) to remove them.
7.3 Cleaning Recommendations
Please follow the following cleaning recommendations to maintain safe sanitary conditions and proper functioning of the machine.
These following suggestions are intended for machines operated during just one daily shift; machines that are used for multiple shifts
should be cleaned more often.
Warning:
 Never use a stream of water to clean any part of this machine!
 ALWAYS use appropriate protection (latex gloves, plastic aprons, etc.) when manually cleaning the
machine.
 ALWAYS wipe the machine thoroughly with a wet sponge or cloth after using any kind of detergent of
disinfectant.
We recommend the use of the following HENKEL brand cleaning and disinfecting products:
Product
Name
Observations
Neutral degreaser with pH 7
TOPAX 10
Due to its neutral pH, no special precautions are necessary. Rinse
thoroughly.
Degreaser for manual cleaning
RIK
Use appropriate precautions and safety gear. Rinse thoroughly.
Alkaline degreaser combined with a
disinfectant
TOPAX 68
Contains corrosion inhibitors. Use appropriate precautions and safety
gear. Rinse thoroughly.
Disinfectant based on quaternary
ammonium salts
TOPAX 91
Use appropriate precautions and safety gear. Rinse thoroughly.
ALWAYS follow the manufacturer’s instructions carefully when using these or any other products.
7.4 General Recommendations for Manual Cleaning
Steps
Products
Tools
Observations
Superficial cleaning
Spatula
Remove large pieces of residue, dismantling smaller parts if
necessary.
Extensive cleaning
Mild detergent
Brush, soaking tub
Let the product work approximately 15 minutes
Rinsing
Warm water
Sponge, tub
Warm water 40/50ºC (100/120º F).
Inspection
Visually examine all accessible parts, especially vital components
and those subject to stress and wear.
Disinfecting
Disinfectants
Sponge, cloth
Perform after completing all other cleaning operations.
Rinsing
Drinking water
Sponge, tub
ALWAYS rinse the machine thoroughly after using any kind of
detergent or disinfectant.
Drying
Cloth
Be sure to thoroughly dry all cleaned components.
Maintenance
Lubricating oil
Cloth
External machine parts.
www.talsaparts.com
www.davisonsbutcher.com