Why does my T&S ChekPoint EC-3100 keep turning on by itself?
If your T&S Plumbing Product is activating without anyone near it, the detection range might be too long; try decreasing the detection zone. Also, examine the surrounding area for anything that could be affecting the range, such as bright lights, reflective surfaces, or direct sunlight.
What to do if T&S Plumbing Product has very low flow?
If you're experiencing very low flow or just a slow dribble from your T&S Plumbing Product, there are a few things you can check: * Make sure the supply stops are fully open. * There might be debris in the solenoid filter; remove it, clean it, and then reinstall it. * The aerator or spray head could also be clogged with debris; remove, clean, and reinstall those as well.
How to fix no water flow with red LED on T&S ChekPoint EC-3100 Plumbing Product?
If your T&S Plumbing Product isn't dispensing water and the red LED is lit, try these steps: First, replace the batteries and ensure the transformer is properly plugged in. If that doesn't work, the sensor range might be too long or picking up the sink; try reducing the range. If the issue persists, the sensor itself may be faulty and require replacement.
What to do if T&S Plumbing Product continues to run?
If your T&S Plumbing Product continues to run even after power has been disconnected, it could be due to debris in the solenoid valve preventing it from closing. Another possible cause is a faulty control module, which would need to be replaced.
Lists parts for EC-3100 and EC-3101 models.
Lists parts for EC-3102 and EC-3103 models.
Lists parts for the EC-3106 model.
Lists necessary tools for faucet installation.
Steps to take before beginning faucet installation.
Instructions for anti-rotation feature on EC-3101 wall-mount.
Instructions for anti-rotation feature on EC-3100/3102 deck-mount.
Explanation of the auto-adjustable scan periods.
How to adjust water flow using control module switches.
Setting auto time-out for water shut-off using switches.
Adjusting the delay for water shut-off after object removal.
Enabling or disabling the auto-flush feature.
Lists tools required for TMV installation.
Step-by-step instructions for installing the thermostatic mixing valve.
Installation steps for EC-HYDROGEN with below deck mixing valves.
General| Brand | T&S |
|---|---|
| Model | ChekPoint EC-3100 |
| Category | Plumbing Product |
| Language | English |
To Next Page
