Do not connect or disconnect a mic with
•
an input when this switch is ON.
Turn this switch
•
ON only when connecting
a condenser microphone that requires
phantom power.
Do not supply phantom power to an
•
unbalanced dynamic microphone.
Some ribbon mics can be damaged by
•
phantom power. If unsure, do not supply
phantom power to a ribbon mic.
Do not use phantom power when line
•
level equipment is connected to an XLR
connector.
u ST/MONO INPUT 1-2 switch
ST/MONO INPUT 3-4 switch
When monitoring two inputs (MIC/INST
IN 1 and MIC/LINE IN 2 or MIC/LINE IN 3
and MIC/ LINE IN 4), use these switches
to set it to mono or stereo.
When a switch is set to MONO, the two
inputs in its pair are mixed, and the mix is
sent to both LINE OUT 1 and 2 jacks.
When a switch is set to ST, the signal
input from the MIC/INST IN 1 (or MIC/
LINE IN 3) connector is output through
the LINE OUT 1 jack, and the signal input
from the MIC/LINE IN 2 (or MIC/ LINE IN
4) connector is output through the LINE
OUT 2 jack.
When only using the MIC/INST IN 1 (or
MIC/LINE IN 3) connector input, set this
switch to MONO to monitor the signal
through both the LINE OUT 1 and LINE
OUT 2 jacks.
i DIGITAL OUT (coaxial) jack
This coaxial digital output jack is
compliant with both consumer IEC 60958
(S/PDIF) and professional IEC 60958 (AES/
EBU) standards.
This outputs the signal input into the unit
by USB from the computer.
Use the US-600 software control panel
on the computer to set which signals are
output.
Connect this jack to a recorder or external
effect device, for example.
o USB port
Use the included USB cable to connect
to a computer with a USB 2.0 compatible
port.
NOTE
This is not compatible with USB 1.1 (12
•
MHz) and cannot be used to connect by
USB 1.1.
This is not compatible with computer
•
Suspend (Sleep) mode. For this reason,
the unit might not operate properly after
a connected computer is brought out of
Suspend (Sleep). In this case, disconnect
the USB cable once and then reconnect it.
p DC IN 5V jack
Connect the included TASCAM PS-
P520 AC adaptor, which meets the
specifications of this unit, here.
2 − Names and Functions of Parts
To Next Page
