Tascam US-600 - 4 - US-600 Control Panel Settings; Clock Source and Output Format; USB Channel Selection and Output Routing

20 TASCAM US-600
Sample Clock Source
The clock source can be set to Automatic or
Internal.
When using digital input, set this to
Automatic.
Automatic
•
(default): If a clock signal is input
through the DIGITAL IN jack, it is used. If
no signal is input through the DIGITAL IN
jack, this unit’s internal clock is used.
Internal
•
: This unit’s internal clock is always
used.
Digital Output Format
Set the digital output format to S/PDIF or AES/
EBU.
“ch1 and ch2” , “ch3 and ch4”
and “ch5 and ch6”
This unit sends 6 channels of signals to the
computer by USB.
Use these settings to select which of
this unit’s inputs signals are sent to each
computer input pair.
Select analog inputs 1-2, analog inputs 3-4 or
digital inputs.
LINE OUTPUTS and DIGITAL
OUTPUTS
The computer inputs 4 channels of signals to
this unit by USB.
Use these settings to select the signals to
be output from this unit’s LINE OUT and
DIGITAL OUT jacks.
Set them to ch1 and ch2 or ch3 and ch4.
NOTE
If you want to output Windows Media Player
or iTunes, for example, through this unit’s
DIGITAL OUT, set the DIGITAL OUTPUTS to
ch1 and ch2 in the Control Panel.
4 – US-600 control panel settings