tau D749MA - Malfunctions: Possible Causes and Solutions; Automation Does Not Start; Radio Control Range Issues; Gate Opens Wrong Way

24 D749MA



programming buttons.

procedure of remote programming of the new transmitters. Follow the procedure written on the










6_   


Radio memory reset:
 
-
ing the operation is complete (if they are not pressed the board reverts to normal operation

Reset (factory setting):
 



MALFUNCTIONS: POSSIBLE CAUSES AND SOLUTION
The automation does not start
 
               
closed (4 green LEDs on).
c- Set dip-switch 6 (phototest) OFF.
d- Increase the FR trimmer to the limit.
 
The radio control has very little range
 
 
c- Do not install the aerial in a low position or behind walls or pillars.
 
The gate opens the wrong way


ENGLISH