18
D749MA
3 - 6 PEDESTRIAN
4 - 6 OPEN/CLOSE
closing of the automation and is regulated based on the func-
5 - 6 STOP
temporarily preventing the automatic closure, if programmed.
7 - 8
INTERNAL
PHOTOCELLS
the opening phase, they temporarily stop the gate until the
stop the gate and then totally open it again.
7 - 9
EXTERNAL
PHOTOCELLS
the closing phase, they stop the gate and then totally open it
Note: the photocell transmitter must always be supplied
by terminals no. 12 and no. 13, since the safety system
test (phototest) is carried out on it. Without this connec-
tion, the control unit does not work. To override the test-
ing of the safety system, or when the photocells are not
used, set dip-switch no. 6 to OFF.
7 - 10
SENSITIVE
EDGE
to allow the obstacle to be removed
.
11 - 12 AUX
12 - 13 TX PHOTOCELLS
14 - 15
FLASHING LIGHT
(LED CABINET)
signal supplied by the control unit, rapid for closing, slow for
16 - 17
GATE OPEN
LIGHT
-
16 - 18
ELECTRIC
LOCK
19 - 20 2
nd
CH RADIO
nd
radio channel output - for control of an additional automa-
tion or for switching on lights, etc... (N.O. clean contact)
Warning: to connect other devices to the 2nd Radio
Channel (area lighting, pumps, etc.), use an additional
auxiliary relay (see note at end of paragraph).
21 - 22 AERIAL
23 - 24 MOTOR (M2)
25 - 26 - 27 ENCODER (M2)
ENGLISH
To Next Page
Loading...
Need help?
General
