Section 5
5-1
Models 340, 341, 342
User Interface
5
User Interface
Figure 5-1
Table 5-1
Note: Standard Door Shown (No Prime Plug)
Symbol Definitions
To better communicate in the international arena, the
words on many of our operator switches and buttons
have symbols to indicate their functions. Taylor
equipments are designed with these international
symbols.
The following chart identifies the symbol definitions used
on the operator switches.
Control Switch
The center position is OFF. The left position is WASH,
which activates only the beater motor. The right position
is AUTO, which activates the beater motor and the
refrigeration system.
Consistency Control
The viscosity (thickness) of the slush is controlled by a
sensing device called the consistency control. The
consistency control knob is located under the control
channel. To achieve a thicker slush, turn the knob
clockwise and counterclockwise to achieve a thinner
slush consistency.
Allow the refrigeration system to cycle on and cycle off
two or three times before an accurate consistency can be
evaluated.
Indicator Light—Add Mix
A mix level indicating light is located on the front of the
machine. When the light is on, it indicates that the mix
hopper has a low supply of mix and should be refilled as
soon as possible. If mix is not added, a freeze-up may
occur, causing eventual damage to the beater, blades,
drive shaft, and freezer door.
For Your Information
The Models 340 and 341 come equipped with an optional
rack assembly and four syrup jars. Each syrup jar holds
16 ounces (453.6 grams) of syrup. One pump stroke will
dispense 1/4 ounce (7 grams) of syrup.
Because of the many different types of syrups on the
market today, the syrup to slush ratio will vary. Consult
the label or manufacturer for the proper amount of syrup
for the desired drink size.
To serve slush product, simply add the flavor and open
the draw valve. The slush product should blend with the
syrup with no stirring necessary. If it does not, the
product is too thick and the consistency control should be
adjusted to a thinner consistency.
Item Description
1 Control Switch
2 Consistency Control
3 Indicator Light - Add Mix
= ON/AUTO
= OFF
= WASH
To Next Page
Loading...
