6-4
OPERATING PROCEDURE
Models 340, 341, 342
Operating Procedure
6
6. Place the large rubber gasket into the groove on the
back side of the freezer door.
Figure 6-12
7. Slide the white, plastic front bearing onto the bearing
hub, making certain that the flanged end of the
bearing is resting against the freezer door. Do not
lubricate the door gasket or front bearing.
Figure 6-13
8. Place the front end of the baffle into the hole in the
center of the door. Position the door onto the four
studs on the front of the freezing cylinder and push
the door into place. Install the four handscrews onto
the studs and tighten them equally in a crisscross
pattern to insure that the door is snug. Do not over
tighten the handscrews.
Note: If the freezer door does not fit into place
easily, position the open end of the beater assembly
in the 11 o’clock position.
Figure 6-14
9. Rotate the baffle assembly so the hole in the end of
the shaft is vertical. Insert the torque arm between
the draw valve spout supports and into the hole in the
baffle assembly.
Note: During operation, the torque arm rests on the
spout support.
Figure 6-15
10. Install the long drip pan into the hole in the front
panel. Install the restrictor cap (if applicable).
Figure 6-16
To Next Page
Loading...
