OPERATING PROCEDURES
6-5
Models 345, 346, 349, 355
Operating Procedures
6
14. Install the freezer door. Position the door on the four
studs on the front of the freezing cylinder. Firmly
push the door into place. Install the four handscrews
on the studs and finger-tighten them equally in a
crisscross pattern to ensure that the door is secure.
Do not over-tighten the handscrews.
Figure 6-18
15. Place the O-ring into the groove of the hopper cover.
Figure 6-19
Install the hopper cover. Lock it into place.
Figure 6-20
Attach the vinyl tube to the pressure relief on the
hopper cover. Position the open end of the vinyl tube
into the rear drip pan.
Figure 6-21
Repeat Steps 1 through 15 for the remaining freezing
cylinders.
16. Install the center drip pan through the front of the
machine.
To Next Page
Loading...
