12
Models 60 & 62Important: To the Operator
Reset Mechanism
The reset protects the beater motor from an overload
condition. If an overload occurs, the reset mechanism
will trip. To properly reset the freezer, set the control
switch to “OFF”. Lift up the right upper side panel and
press the reset button firmly. Turn the control switch to
“WASH” and observe the freezer’s performance.
Return the control switch to the “AUTO” position to
resume normal operation.
If the reset mechanism should trip again, contact your
authorized Taylor Distributor to resolve the problem.
Figure 1
Consistency Control*
The viscosity (thickness) of the shake is controlled by
a sensing device called the consistency control. The
consistency control switch is located below the control
switch. To achieve a thicker shake, turn the knob
clockwise and counterclockwise to achieve a thinner
shake consistency.
Allow the refrigeration system to cycle on and off two
or three times before an accurate consistency can be
evaluated.
Spinner Rinse Switch*
The spinner rinse switch is located next to the
consistency control knob. To clean the spinner housing
from syrup residue:
1. Place the control switch in the “AUTO” position.
2. Hold a cup under the spinner housing.
3. Press the spinner rinse switch. Water will flow
until the switch is released.
4. Release the switch when the housing has been
thoroughly rinsed.
Auto Lift Switch (Model 60 Only)*
The auto lift switch is located below the flavor selector
switch. To draw product, the auto lift switch may be
used. Press the switch. Just before the desired level
in the cup is reached, release the switch. The draw arm
will lower the draw valve and the product will stop
flowing.
Foot Pedal (Model 60 Only)
The foot pedal is located on the lower front of the
machine. To draw product from the Model 60, the foot
pedal may be used. Press the foot pedal. Just before
the desired level in the cup is reached, release the foot
pedal. The draw arm will lower the draw valve and the
product will stop flowing.
Figure 2
Flavor Selector Switch*
The flavor selector switch consists of four flavor
buttons. The left button controls the No. 1 tank and its
lines. The second button from the left controls the No.
2 tank and its lines. The third button from the left
controls the No. 3 tank and its lines. The right selector
button (“Van”) is the “OFF” button and may be used to
dispense the unflavored product as a vanilla shake.
*See illustration, page 11.
To Next Page
Loading...
