Taylor 60 - Door and Beater Assembly

OPERATOR PARTS IDENTIFICATION
4-3
Models 60 and 62
Operator Parts Identification
4
Door and Beater Assembly
Figure 4-3
Items 19, 20, 21, and 17 used on Model 60 only
*Bulk Part Number is R30314
**Not Shown
14
13
12
8
7
3
2
10
1
4
12
5
6
11
15
17
18
19
20
21
9
16
Item Description Part No.
1 Nut-Stud 021508
2 O-ring- 1- 1/16 OD X .139W 084545
3 Valve A.-Draw X46671
4 Bearing-Spinner 017032
5 O-ring-.291 ID x .080W 018550
6 Arm-Torque 014500
7 Torque A. X17381
8 Bearing-Guide 014496
9 Gasket-Door 016672
10 Bearing-Front 013116
11 Beater A.-7QT-1 Pin X46233
12 Blade-Scraper-Plastic 9-13/16L 084950
13 Shaft-Beater 035527
14 Seal- Drive Shaft 032560
15 Door A.-Partial-1 SPT X17373-SER
Item Description Part No.
16 Housing-Spinner *4 SPIG 017269
17 Blade A.-Spinner 8-3/8”
(Not used in 006227CANH,
006233CANH, 006027CANH,
006033CANH, 0H6027CWMK and
0H6033CWMK)
X35570
18 Blade A.-Spinner (Used in
006227CANH, 006233CANH,
006027CANH, 006033CANH,
0H6027CWMK and
0H6033CWMK only)
X16961
19 O-ring-5/16 OD x .070W
(Model 60)
016272
20 Fitting-QD Male Insert (Model 60) 036296
*21 Tube-Vinyl 3/16ID x 1/16 Wall
(Model 60)
020940-6