Taylor 8752 - Cleaning

6-4
OPERATING PROCEDURES
Models 8752, 8756, and 8757
Operating Procedures
6
14. Insert the baffle rod(s) through the beater(s) in the
freezing cylinder(s). With the door seated on the
freezer studs, install the handscrews. Tighten equally
in a crisscross pattern to ensure the door is snug.
Note: On Models 8756 and 8757, the short
handscrews go on the bottom and the long handscrews
go on the top.
Figure 6-11
15. Install the draw valve(s). Slide the two O-rings into
the grooves on the draw valve(s) and lubricate.
Figure 6-12
Note: Models 8756 and 8757 have three draw
valves.
16. Lubricate the inside of the freezer door spout(s), top
and bottom, and insert the draw valve(s) from the
bottom until the slot in the draw valve(s) comes into
view.
Figure 6-13
17. Install the adjustable draw handle(s). Slide the
O-ring(s) into the groove(s) on the pivot pin(s) and
lubricate.
Figure 6-14
18. Slide the fork of the draw handle(s) in the slot of the
draw valve(s). Secure with pivot pin.
Note: Models 8756 and 8757 have three draw
handles and two pivot pins. Slide the fork of the draw
handle in the slot of the draw valve, starting from the
right. Slide the long pivot pin through the right and
middle draw handles. Secure the left draw handle
with the short pivot pin.
Figure 6-15
Apply the appropriate
Taylor approved food safe lubricant.
Apply the appropriate
Taylor approved food safe lubricant.