Taylor 8752 - Page 51

Section 9
9-1
Models 8752, 8756, and 8757
Parts Replacement Schedule
9
Parts Replacement Schedule
Table 9-1
* Double quantity for Models 8756.and 8757
** Triple quantity for Models 8756.and 8757
Part Description
Every 3
Months
Every 4
Months
Every 6
Months
Annually Qty.
Scraper Blades X 2*
Driveshaft Seal X 1*
Freezer Door Gasket X 1*
Front Bearing X 1*
Beater Shoes X 2*
Draw Valve O-ring X 2**
Prime Plug O-ring X 2*
Pivot Pin O-ring X 1*
Air/Mix Pump O-ring X 4*
Liquid Valve Body Check Band X 3*
Mix Inlet Fitting O-ring X 1*
Pressure-Switch Diaphragm X 1*
Design Cap X 1**
White Bristle Brush, 9/16 in. x 44 in.
(14 mm x 1.12 m)
Inspect and
replace if
necessary.
Minimum 1
White Bristle Brush, 1 in. x 2 in.
(25 mm x 51 mm)
IInspect and
replace if
necessary.
Minimum 1
White Bristle Brush, 3 in. x 7 in. 
(76 mm x 178 mm)
Inspect and
replace if
necessary.
Minimum 1
White Bristle Brush, 3 in. x 1/2 in. 
(76 mm x 13 mm)
Inspect and
replace if
necessary.
Minimum 1
Small White Bristle Brush Inspect and
replace if
necessary.
Minimum 1
Double-Ended Brush Inspect and
replace if
necessary.
Minimum 1
Black Bristle Brush, 1 in. x 2 in. 
(25 mm x 51 mm)
Inspect and
replace if
necessary.
Minimum 1