Taylor C125 - 6 Trouble-Shooting

ENGLISH - 14
6. TROUBLE-SHOOTING
TROUBLE
POSSIBLE CAUSES
REMEDIES
the machien does not start
(pushbutton ON-OFF is activated
with green led)
master switch oper
turn the switch off
cover lifted up or not assembled
lower the cover and /or verify if it is
correctly assembled
select “cyclic agitation”
verify that the led of the
pushbutton “cyclic agitation” is
grey
incorrect power supply
verify supply
Electrical trouble.
Send a technician
Since the first phases of the batch
freezing cycle, the compressor
works intermittently
condensator dirty or fan broken
clean condensator with a brush
and verify the fuctionning of the fan
motor
The freezing period is too long and
the ice-cream is wet.
insufficient condensating
check that between the lateral left
panel and the wall or other
obstacles there is at least 30 cm
space
high ambient temperature
verify that the ambient temperature
is not higher than 25°C
too high mix temperature
The max. production of the
machine is reached using liquid
mix at 4 °C. Using mix at higher
temperature, the freezing time
becames longer, which is normal
and is not a trouble.
Worn out agitator scraper
verify and replace if required
trouble in the freezing system
send a technician
the product is too soft
insufficient freezing time
select on the timer a longer time-
period
the product is too hard
excessive freezing time
select on the timer a shorter time-
period
durino the batch freezing the
machine is noisy
presence of ice on the cylinder wall
the ice cream is ready to be
extracted
verify that the mix quantity is not
less than the required minimum
one.
the belt slip
send a technician
driving shaft bearing worn out
send a technician