OPERATING PROCEDURES
6-13
Model C300
Operating Procedures
6
3. Remove the:
• Seals and O-rings from the drive shafts
• drive shaft seal bushings from drive shaft seals
• caps and springs from freezer doors
• screws and draw handle slides from freezer
doors
• Pivot pins from draw valves
• Draw valve handles from freezer doors
• Draw valves from freezer doors
• O-rings from draw valves
• Prime plugs from freezer doors
• O-rings from prime plugs
• O-rings and front bearings from freezer doors
Discard all O-rings and replace them with new ones.
Note: To remove O-rings, use a single-service towel
to grasp the O-ring, and apply pressure in an upward
direction until the O-ring pops out of its groove. With
the other hand, push the top of the O-ring forward
until it rolls out of the groove and can be removed
easily.
4. Using a single- service towel, wipe the lubricant off
the parts. Brush- clean all disassembled parts in the
cleaning solution. Make sure all lubricant and syrup is
removed. Place all the cleaned parts on a clean, dry
surface to air- dry..
5. Wipe clean all the exterior surfaces of the unit.
To Next Page
Loading...
