23
Model C713 Operating Procedures
Step 11
Slide the two o-rings into the grooves on each prime
plug. Apply an even coat of Taylor Lube to the
o-rings and shafts.
Figure 35
Step 12
Insert the prime plugs into the holes in the top of the
freezer door and push down.
Figure 36
Step 13
To install the freezer door, insert the baffle rods
through the beaters in the freezing cylinders.
Figure 37
With the door seated on the freezer studs, install the
handscrews. Use the long handscrews on the top
and the short handscrews on the bottom. Tighten
them equally in a criss-cross pattern to insure the
door is snug.
Figure 38
To Next Page
Loading...
