24
Model C713Operating Procedures
Step 14
Slide the three o-rings into the grooves of each
standard draw valve. Slide the H-ring and o-ring into
the grooves of the center draw valve. Lubricate the
H-ring and o-rings.
Figure 39
Step 15
Lubricate the inside of the freezer door spouts, top
and bottom.
Figure 40
Step 16
Insert the draw valves from the bottom until the slot
in the draw valves come into view.
Figure 41
Step 17
Slide the fork of the draw handles in the slot of the
draw valves, starting from the right.
Figure 42
Step 18
Slide the pivot pin through each draw handle as they
are inserted into the draw valves.
Figure 43
To Next Page
Loading...
