USER INTERFACE
5-9
Model C722
User Interface
5
L/R HPR>59F (15C)—The mix temperature in the
hopper exceeded 59°F (15°C).
L/R BRL>59F (15C)—The mix temperature in the
freezing cylinder exceeded 59°F (15°C).
L/R HPR>45F (7C) AFTER 1 HR—The mix temperature
in the hopper was above 45°F (7°C) for more than 1 hour.
L/R BRL>45F (7C) AFTER 1 HR—The mix temperature
in the freezing cylinder was above 45°F (7°C) for more
than 1 hour.
L/R HPR>41F (5C) AFTER 4 HR—The mix temperature
in the hopper was above 41°F (5°C) for more than 4
hours.
L/R BRL>41F (5C) AFTER 4 HR—The mix temperature
in the freezing cylinder was above 41°F (5°C) for more
than 4 hours.
L/R HPR>41F (5C) AFTER PF—The mix temperature in
the hopper was above 41°F (5°C) for more than 4 hours,
following a power failure.
L/R BRL>41F (5C) AFTER PF—The mix temperature in
the freezing cylinder was above 41°F (5°C) for more than
4 hours, following a power failure.
Note: Refer to your local health codes regarding
temperature recommendations for procedures to follow if
these fault screens appear.
The system information is displayed on three separate
screens. The first screen contains the control and
software version installed in the machine.
Press the SEL symbol to advance to the next system
information screen containing the software language
version.
Press the SEL symbol to advance to the third system
information screen containing the model bill of material
and machine serial number. Pressing the SEL symbol
again will return to the Manager's Menu.
The CURRENT CONDITIONS screen displays the
current viscosity, and the hopper and barrel
temperatures. Press the SEL or MENU
symbols to
return to the Manager's Menu.
The NET SERVICE PIN screens allows the manager to
initialize a network connection for networking kitchens.
Use the arrow symbols to move the cursor up or down.
Pressing the SEL symbol with the arrow cursor next to
No will return to the Manager's Menu. Pressing the SEL
symbol with the arrow cursor next to Yes will connect to
the network if a gateway card is connected.
Note: If Yes is selected, it may take a few moments for
the memory to clear and the defaults to load. The display
may show the message COMMUNICATIONS FAILURE
during this time.
SOFTWARE VERSION
C722 CONTROL UVC4
VERSION V00.00.000
> Next
Language
V4.00 English
> Next
B.O.M. C700000000
S/N K0000000
> Next
VISC 0.0 0.0
HOPPER 41.0 41.0
BARREL 41.0 41.0
NET SERVICE PIN
ARE YOU SURE?
Yes
> No
To Next Page
Loading...
Need help?
General
