51
1. Using the grill scraper, scrape the grease on the
lower grill plate from front to back. Do not scrape
across the rear of the lower grill plate with the grill
scraper. See
Figure-93.
Figure-93
2. Use the wiper squeegee to clean the release sheet
on the upper platen. Use a diagonal motion to clean
the sheet. Hold the handle at a slightly upward angle,
with the wiper end facing downward.
See Figure-94.
Figure-94
Note: Do not use excessive pressure when wiping the
release sheet with the squeegee. Using excessive
pressure can scratch or tear the release sheet.
3. Using the wiper squeegee, push the grease at the
rear of the lower grill plate into the grease can.
Do not use the grill scraper for this step.
See Figure-95.
Figure-95
4. Use the grill cloth to clean the rear grease shield and
the bullnose areas as needed during operation.
Note: To increase the life of the release sheet, wipe it
with a damp, folded grill cloth a minimum of four times
every hour.
Display the Current Status
Note: The actual temperatures may be displayed at any
time, including during a Cook cycle.
Press the Information key . The following
information will be displayed:
• The current grill temperatures for the upper and
lower plates.
• The ambient temperature of the control board.
• The Clean key displays the time since the
grill was last cleaned and the length of time it
took to clean the grill.
• The Auto Calibrate key indicates if the grill
is calibrated and the current menu item.
To Next Page
Loading...
Need help?
General
