17
Models QS12/QS24
Controls and Systems
Step 4
For each cook surface requiring adjustment, place 4
gap blocks on the cook surface, approximately 2”
(51 mm) in from each corner.
Figure 6
Step 5
Lower the cook surface assembly. Loosen and slowly
move the T -handle to the left until the gap pins in the
gap slides touch the cook surface, and tighten the
T -handle.
Figure 7
Step 6
Wearing proper protection, carefully attempt to raise
the gap slide to evaluate which gap pin is in need of
adjustment.
Figure 8
With the gap slide raised, slowly turn the gap pin
needing adjustment until it makes contact with the
cook surface. Repeat these steps for both gap
slides.
Figure 9
Step 7
Raise the upper cook surface and remove the four gap
blocks.
To Next Page
Loading...
