delayed response to the pitch movement of your singing
voice. It is also referred to as “Glide” in synthesizers.
The range of values equals approximately how long the
upwards or downwards slide will take to reach each new
note. Setting each voice to different values greatly assists
the illusion of other singers singing with you.
V1 to V4 SMOOTHING
At low values, Smoothing acts like pitch correction for
the harmony voices. With the voices corrected like this,
some Portamento is usually required to help soften note
to note transitions unless a robot-like effect is desired.
Higher values offer progressively less correction. Like
Portamento, setting each voice with a unique value of
the Smoothing parameter helps the harmonies sound
more natural.
V1 to V4 GENDER
Each voice has its own timbre adjustment in the form of
the GENDER control. Values below 0 lend each voice
a more masculine and deeper effect and values above 0
lend a more feminine or thinner effect.
LEAD LEVEL
Controls the lead (dry + Tone) voice level when
the individual effect is turned on with its respective
footswitch. This allows a unique wet/dry mix for
individual effects. When multiple effects are active, the
lowest LEAD LEVEL value will determine the value.
Note that the LEAD EFFECT SENDS parameter on the
PRESET tab must be set to PRE in order for any signal to
get to the effect block when LEAD LEVEL is set to OFF.
The Edit Menu: DOUBLE Tab
73