TC-Helicon Voicelive 2 User Manual

Overview
The Harmony block in VoiceLive 2 produces up to 8
harmony voices and is the home of the Choir effect.
IMPORTANT NOTE: The parameters available on the
HARMONY Tab and their organization differs depending
on the value of the NATURALPLAY parameter at the
bottom of the tab. This section begins by describing the
most common NATURALPLAY harmony mode: AUTO
INPUT SENSE. Following the parameter descriptions for
AUTO INPUT SENSE, exceptions and differences for
the other NATURALPLAY modes are listed.
STYLE
Use the soft knob assigned to this parameter to choose a
Harmony style you like. Styles configure useful settings to
pre-programmed values to allow you to make changes
quickly. The selection of styles will change depending on
the setting of the NATURALPLAY parameter.
LEVEL
Sets the level for the overall Harmony effect in the
current preset.
V1 to V4 VOICING
Here you set the pitch shift intervals of voices 1 through
4 relative to your input pitch. The names of the intervals
change depending on NATURALPLAY mode. In the
two MIDI NOTES modes, the VOICING parameters
disappear entirely. The options start at the lowest
harmony interval and go the highest.
V1 to V4 LEVEL
The four knobs control the relative volume of each
voice. This is also where voices are turned on an off. The
range of values goes from Off to 0 dB (Full). Typically
all voices are set at the same level unless you want to
highlight or minimize a particular voicing interval.
V1 to V4 GENDER
Each voice has its own timbre adjustment in the form of
the GENDER control. Values below 0 lend each voice
a more masculine and deeper effect and values above 0
The Edit Menu: HARMONY Tab
63

TC-Helicon Voicelive 2 Specifications

Operating Environment

operating temperature	32° F to 122° F (0° C to 50° C)
storage temperature	-22° F to 167° F (-30° C to 70° C)
humidity	Max. 90 % non-condensing

Power

external power supply mains voltage	100 to 240 VAC, 50 to 60 Hz
power consumption	<14 W

Analog Inputs

mic input impedance	2.14/1.07 kOhm
line input impedance	13/6.5 kOhm
guitar input impedance	1 MOhm

Analog Outputs

output impedance	100/50 Ohm
output range	16 dBu / 0dBu
dynamic range	> 109 dB, 20 Hz to 20 kHz

Weight and Dimensions

dimensions	13.8" x 3" x 8.5" (350 x 76 x 216)
weight	5 lb. (2.3 kg)