TC-Helicon Voicelive 2 User Manual

DUCKING AMOUNT
This sets how much attenuation (gain reduction) is
applied to the reverb signal when a vocal is present. For
ducking to not be too obvious, a slight reduction of -6
is best. The DUCKING parameter must be set to ON
for this to have any effect.
DUCKING TIME
Ducking time sets how long it takes to ramp up the
reverb level at the end of vocal phrases.
LEAD to REV
Sets the amount of lead level sent into the Reverb block.
HARM to REV
Sets the amount of harmony level sent into the Reverb
block. Harmonies must be on to feed this send.
DEL to REV
This allows you to feed the reverb block with the effected
output of the delay block. The DELAY footswitch must
be on to feed this send.
LEAD LEVEL
Controls the lead (dry + Tone) voice level when
the individual effect is turned on with its respective
footswitch. This allows a unique wet/dry mix for
individual effects. When multiple effects are active, the
lowest LEAD LEVEL value will determine the value.
Note that the LEAD EFFECT SENDS parameter on the
PRESET tab must be set to PRE in order for any signal to
get to the effect block when LEAD LEVEL is set to OFF.
The Edit Menu: REVERB Tab
62

TC-Helicon Voicelive 2 Specifications

Operating Environment

operating temperature	32° F to 122° F (0° C to 50° C)
storage temperature	-22° F to 167° F (-30° C to 70° C)
humidity	Max. 90 % non-condensing

Power

external power supply mains voltage	100 to 240 VAC, 50 to 60 Hz
power consumption	<14 W

Analog Inputs

mic input impedance	2.14/1.07 kOhm
line input impedance	13/6.5 kOhm
guitar input impedance	1 MOhm

Analog Outputs

output impedance	100/50 Ohm
output range	16 dBu / 0dBu
dynamic range	> 109 dB, 20 Hz to 20 kHz

Weight and Dimensions

dimensions	13.8" x 3" x 8.5" (350 x 76 x 216)
weight	5 lb. (2.3 kg)