36
Troubleshooting cont.
I’m singing, but I can’t hear anything!
- Make sure you’ve turned up the input gain, so that the INPUT LED is lighting green.
- Have you plugged in your headphones or connected to a P.A.?
- Is the P.A. turned on, connected to its speakers and recieving signal?
If not, check your P.A. manual to make sure everything is set up correctly.
- Are you using a condenser mic? Did you make sure to change the mic type to condenser in
the setup menu?
I’ve turned on the Harmony Effects, but they don’t sound right.
- Did you select a Key/Scale? Is it the right key for the song?
- If you’re using RoomSense to listen for Key information, make sure it’s close to whichever
instrument is playing the most clearly dened chords. (Rhythm Guitar, Piano etc.)
- If you’re using an mp3 player to sing along with tracks, set the AUX IN TYPE to Tracks in the
SETUP menu. (Some tracks will work better for NaturalPlay than others, based on the mix and
instrumentation of the recording)
- If you’re using Guitar or MIDI to control Harmony, make sure you’ve got the Key set to
AUTO on the Harmony effect page.
None of the effects seem to be making any changes to the sound.
- Is the unit in Talk mode? If the HIT LED is ashing, tap it once to return to normal mode.
How do I get back all of the Factory Presets?
-When powering up the unit, press and hold the two “arrow” buttons next to the Control
Knob.
*Any changes you have made to presets will be erased. Back up your custom presets via
VoiceSupport.
How do I perform a full Factory Reset?
-When powering up the unit, press and hold “Back” and “Store”.
*Any changes you have made to presets or setup information will be erased. Back up your
cutom presets and setup data via VoiceSupport.
To Next Page
Loading...
Need help?
General
