14
Setup - System
LCD Contrast – Controls the contrast of the LCD screen. Depending on the ambient light in the
room, different settings may have more or less effect.
UP/DN Function – Set the behavior of pressing the UP/DN footswitches simultaneously.
1. LOOPING – Enters LOOP mode
2. SET KEY – Enters KEY/SCALE mode
Lead Dly – Delays the incoming vocal signal very slightly to compensate for the small amount of
latency introduced when effects are processed by the system. This delaying of the signal allows the
output voices, like harmonies, to be perfectly in sync with the lead vocal.
There are 3 settings:
1. OFF – No delay compensation is used.
2. VOICE SYNC – The lead vocal is delayed an amount equal to the maximum latency of the sys-
tem with all effects turned ON.
3. AUTO – The lead vocal will be delayed by an amount equal to the latency of the currently
enabled effect blocks. Using more effect blocks will increase the latency compensation amount.
Tune Reference – Default is 440Hz and can be changed in 0.5Hz increments.
Pitch Pipe Level – Controls the level of the Pitch Pipe in the Practice screen.
Aux in Type – Performs magical calculations to help make harmonies more accurate.
There are 2 settings:
1. LIVE – Use when you are playing live or processing a recorded vocal track from your DAW us
ing the AUX in to provide guide tracks.
2. TRACKS – Use when you’re singing along with pre-recorded music, like an mp3 player.
To Next Page
Loading...
Need help?
General
