TCS 3000 - PRODUCT PRICES

To Next Page

To Previous Page

Selecng the Host Register

Select Register as Host:

PRINTER SETTINGS → DISABLE/ENABLE HOST → ENABLE

Select the Client Range:

PRINTER SETTINGS → PRINTER HOST → CLIENTS ADDRESS RANGE → CLIENTS RANGE START ADDRESS [ Enter 2 and

Select] →

CLIENTS RANGE END ADDRESS [ Enter the number of Registers on the Chain and Select]

*Please Note the Host is always # 1. The Client always starts at #2*

Selecng the Client Register

Enable the Printer:*

PRINTER SETTINGS → ENABLE/DISABLE PRINTER → ENABLE PRINTER

Select the Printer:*

PRINTER SETTINGS → SELECT PRINTER → [REMOTE] → ENABLE

SYSTEM SETTINGS → CONNECTIVITY SETTINGS → NETWORK SETTINGS → ADDRESS → DEVICE ADDRESS [Select the

number of the unit you are using ex. 2 if it is the second register on the chain or 3 if it’s the third register on the chain.]

To Connect to the Chain:

SYSTEM SETTINGS → CONNECTIVITY SETTINGS → NETWORK SETTINGS → INTERFACE BRIDGE [Only used when there

are 2 Registers ed in the chain] → TRANSFER DATA BETWEEN RS232 <-> RS485 INTERFACES ENABLED

Connue the Selecng Client Register steps for every Client on the Chain.

You may only use the Daisy Chain on ve devices at a me. You may not Chain more than ve devices together.

Other manuals for TCS 3000