TCS 3000 Operation Manual

16
Select Function
PULSE OUTPUT
The solid state pulse frequency transmission of a scalable pulse factor
Enable/Disable Enable or disable operation
Configure Sets the DEFAULT for pulse transmission output data
Delivery Total (Currency)
Gross Volume
1 (1 pulse per unit)
1.1 (10 pulses per unit)
1.11 (100 pulses per unit)
1.111 (1000 pulses per unit)
Net/Auto Volume
1 (1 pulse per unit)
1.1 (10 pulses per unit)
1.11 (100 pulses per unit)
1.111 (1000 pulses per unit)
Pulse Repeater repeats the incoming pulse value
Startup Reset Enable or disable and press ENTER
RFID READER
RFID is for fixed location or fleet refueling
External External is used for remote readers
ThinkMagic ThinkMagic is for fixed locations
CONNECTIVITY
Connectivity is used for accessory communication settings
Network Settings
Interface Interface is for handheld communication. An interface is required for this setting.
Address Device Address will assign the TCS 3000 the unique address within the Daisy
Chain communication sequence. Primary Host will always be number one (1) and
the Client Address range will be two (2) through eight (8).
Printer Settings
Enable/Disable Enable or Disable for operation
Select Printer Select desired printer to be used with the system
Printer Host Enable or Disable a printer host
Clients Address Range Displays the range between Client and Host in a daisy chain.
MISC SETTINGS
L1 Password Level one (1) password protection for System Settings.
Procedure to set L1 Password is as follows:
1. Highlight L1 Password and press ENTER.
2. Highlight Set Password and press ENTER.
3. Input alphanumeric password and press ENTER.
4. Confirm password entry by resubmitting password, and press ENTER.
NOTE: Alphanumeric password must be at least three (3) characters long.

TCS 3000 Specifications

General

Brand	TCS
Model	3000
Category	Measuring Instruments
Language	English