18
5. For load wires with a diameter greater than 11 millimeter divide each bus bar cover plug into
two separate parts by bending and breaking it along its separate grooves, as illustrated in
Figure 20. Insert only the rounded parts into the bus bar protection bracket and fix it to the
output cover using two SEMS screw. Insert output cover assembly through the cables as
illustrated in Figure 20.
Figure20:Three60V‐100VUnits,WireDiameter>11mm,OutputCoverAssembly
6. Assemble one lug on each bus bar using one hexagon bolt, two plain washers, one helical
spring-lock washer and one hexagon nut as illustrated in Figure 21.
Figure21:Three60V‐100VUnitsLugsAssembly
M3x8SEMSScrew,NickelPlated
Tighteningtorque:4.7‐5.7Lbf‐inch(0.53‐0.64Nm)
Forrecommendedlugsrefer
to seriesSafety&
InstallationManual.
Notsupplied.
HexagonNut,M8,StainlessSteel
M8x25HexagonBolt,StainlessSteel
Tighteningtorque:106‐132Lbf‐inch(12‐14.9Nm)
To Next Page
Loading...
