Teac A-6010GSL - Erase Head Alignment; Record Head Alignment; Playback Heads Alignment

u
5. HEAD MECHANICAL ALIGNMENT
NOTE: Head alignment is adjusted at the factory to very critical
tolerances, Normally head assembly replacement will require only
minor alignments or adjustments. Complete readjustment should
only be necessary after an individual head is replaced.
The adjustments are made as follows’:
ERASE HEAD: The erase head pole should be above the edge of a
threaded tape by the width of a heavy pencil line. Adjust the three
screws indicated to obtain this height.
RECORD HEAD: The record head pole should be above the edge of a
threaded tape by the width of a thin pencil line. Adjust the two
screws indicated to obtain this height.
IMPORTANT: After completing the
height adjustment make certain
head surfaces are paraliel with
tape guide surfaces when viewed
from the sidey
PLAYBACK HEADS: The reverse playback head pole should be even with
the bottom of the tape and the forward play head pole should be even
with the top of the tape. Adjust the screws indicated.
NOTE: Refer to figure for locating the screws used in the preceding
alignments and azimuth adjustments are given in the section on
MEASUREMENT AND ADJUSTMENT -ELECTRICAL~.
econo REVERS FORWARD
oxwesce
Fig. 5-L Head Mechanical Alignment